A single layer of a 3D printed model. Slices vary in thickness depending on the settings used in the Slicer (ex. 0.2 mm).

Click Here to Leave a Comment Below 1 comments
Tips für 3dDruck Anfänger: Tip 7 von Josh Ajima | 3dDinge - Alles rund um 3d-gedrucktes - June 25, 2015

[…] Slice your model using the manufacturer’s recommended slicer and settings. Try to adjust one thing at a time between prints and keep notes about the settings and effect on the print. Label test prints with a sharpie and take photographs. […]


Leave a Reply: